# Aspire Zelos M80, from a tight draw to RDL with one kit

> Aspire Zelos M80, three vaping styles claimed and two actually covered. The eight coils sorted by draw, the airflow ring and moving from MTL to RDL.


Aspire sells this kit as a do-it-all device. The official page for the **Aspire Zelos M80** describes it as "optimized" for mouth-to-lung, restricted direct lung and direct lung vaping, with a smooth draw on one side and bold clouds on the other. Three styles, one box. The tank and coils in the kit still have to keep that promise, because the tank, not the mod, decides how air and vapour reach you.

## Aspire Zelos M80, which draw comes in the box

The Aspire Zelos M80 covers two draws, not three. With the 1.8 ohm BVC coil supplied as a spare, it gives a tight mouth-to-lung (MTL) draw. With the 0.3 ohm Meshed coil fitted at the factory, it moves into restricted direct lung, or RDL.

Full direct lung vaping, which the product page also claims, stays out of reach of the Nautilus 3SR tank in the kit. None of the eight compatible coils goes above 28W, a ceiling that keeps the kit within tight and restricted draws.

## Three styles claimed, two delivered by the Nautilus 3SR

The promise and the hardware do not quite speak the same language. That gap shows up when you compare two pages published by the manufacturer itself.

The kit page lists "MTL/RDTL/DTL" and talks about "bold DTL clouds". RDTL is Aspire's spelling for RDL, and DTL stands for direct lung. The page for the **Nautilus 3SR** names no draw style at all. It describes bottom adjustable airflow and lists the compatible coils, without a word on how to inhale.

So the coil list settles the question. It runs from 7 to 28W, a range that suits tight and restricted draws but never reaches the power of coils built for big clouds. The mod goes up to 80W, yet that changes nothing while the Nautilus 3SR stays on top.

## The Aspire Zelos M80 coils sorted by draw

Eight coils fit the tank in the kit, and their resistance gives a first clue to the draw. The table sorts them using the threshold we use across this site, above 1 ohm for a tight draw and below it for a restricted one.

| Coil | Resistance | Published range | Intended draw |
|---|---|---|---|
| Nautilus BVC | 1.6 ohm | 7 to 11W | Tight (MTL) |
| Nautilus BVC (supplied) | 1.8 ohm | 10 to 14W | Tight (MTL) |
| Triton Mini Clapton | 1.8 ohm | 13 to 16W | Tight (MTL) |
| Nautilus Meshed | 1.0 ohm | 13 to 15W | Tight, on the edge of RDL |
| Nautilus 2 | 0.7 ohm | 18 to 23W | RDL |
| Nautilus 2S Meshed | 0.7 ohm | 20 to 25W | RDL |
| Nautilus 2S | 0.4 ohm | 23 to 28W | Open RDL |
| Nautilus Meshed (pre-fitted) | 0.3 ohm | 23 to 28W | Open RDL |

### The four coils for a tight draw

The two BVC coils and the Triton Mini Clapton run between 7 and 16W. At these low settings they produce a discreet, warm vapour, the kind a mouth-to-lung draw looks for, where each puff stops in the mouth first.

The 1.0 ohm Meshed coil sits on the border. Its 13 to 15W range keeps it on the tight side, and its value, right on the 1 ohm threshold, makes it an in-between choice.

### The four coils for RDL

The Nautilus 2 and 2S coils, along with the 0.3 ohm Meshed, run from 18 to 28W. They feed **restricted direct lung** vaping, a one-step inhale where vapour goes straight down while the draw is still held back. The two lowest values, 0.4 and 0.3 ohm, push that restricted draw towards a fuller puff.

## The airflow ring, the other half of the setting

A coil sets the range of the draw, and the airflow ring tunes it within that range. On the **Aspire Zelos M80**, the ring sits at the base of the tank, just above the mod.

The user manual calls it the AFC ring and places it next to the air inlet, on the lower part of the Nautilus 3SR. Turning it brings holes of different sizes in front of the air inlet.

Aspire does not publish how many holes there are. The review of the kit published by Vaping Post counts seven, of increasing size, with the smallest giving a very tight draw and the largest a lively RDL. One retailer page even describes top airflow adjustment in a text that elsewhere places it at the bottom, which is a good reason to rely on the drawings in the manual.

In practice, you close the ring with a BVC coil and open it step by step with a low-resistance mesh. Our guide to [vape airflow settings](/uk/vape-airflow-settings/) walks through that process one notch at a time.

## Moving from MTL to RDL on the Aspire Zelos M80

Switching style on this kit takes three steps, in an order that avoids firing a dry coil. Going back to a tight draw means the same steps in reverse.

### Changing the coil from the bottom

According to the drawings in the manual, you unscrew the base of the tank, pull out the used coil firmly, push the new one in and screw the base back. In the UK, the Nautilus 3SR is sold in its 2ml TPD version, as refillable tanks are capped at 2ml, and nicotine e-liquid comes in bottles of 10ml at no more than 20mg/ml.

A new coil needs to soak before the first puff. The manual asks you to let the filled tank stand for 5 minutes.

### Setting the power within the coil's range

The mod starts in WATT mode at 5W, which is too low for every coil on the list. Raise it to the bottom of the range printed on the coil, then go up in small steps until the draw feels right.

### Opening the airflow and matching the e-liquid

Moving to RDL goes with a more open ring. The e-liquid usually follows the same direction, with a higher vegetable glycerine base for a low-resistance mesh and a thinner blend, often around 50/50, for a BVC coil on a tight draw. Our guide to [RDL vaping](/uk/rdl-vaping-restricted-direct-lung/) explains what this style changes in the way you inhale.

## Direct lung vaping, what the kit is not built for

Direct lung vaping calls for lower resistances and higher power than the Nautilus range offers. With the tank supplied, the Aspire Zelos M80 does not get there, whatever the mod setting.

To vape that way, you need a different tank designed for direct lung. Aspire lists the mod at 74 x 25 x 35.3mm without saying which figure is the width, and the product page gives no maximum tank diameter. Check that another tank will not overhang the mod before fitting it.

The Nautilus GT, another tank from the same family, follows the same logic. Our page on the [Nautilus GT and its MTL to RDL settings](/uk/nautilus-gt-tank/) shows that these coils also stop at a restricted draw.

## Related reading

- [Vape airflow settings, adjusting your draw](/uk/vape-airflow-settings/)
- [RDL vaping, restricted direct lung explained](/uk/rdl-vaping-restricted-direct-lung/)
- [Nautilus GT, GT Mini or GT II, setting the draw from MTL to RDL](/uk/nautilus-gt-tank/)
- [MTL vaping, the guide to a tight draw](/uk/mtl-vaping-tight-draw/)

## FAQ

Five practical questions about the kit, most of them answered by Aspire's own manual.

### How do you unlock the Aspire Zelos M80?

There are two levels of locking. Holding "+" and "-" together for 1.5 seconds locks or unlocks the adjustment buttons only. The side switch locks the whole mod, which then shows "SLIDE THE SWITCH" whenever a button is pressed, until you move the switch back to the open position.

### What does the Check Atomizer message mean?

The manual links this message to open circuit protection. In other words, the mod cannot detect a coil, often because the coil is not pushed in fully or the base of the tank is not screwed down far enough.

### Should you clean condensation from the tank?

Yes, the manual includes a drawing showing a cotton bud for this. It does not set a frequency, but wiping it when you change a coil or an e-liquid is part of the same maintenance step.

### How do you replace the Nautilus 3SR glass tube?

Firmly unscrew the top cap, push the used tube out, fit the new one, then screw the top cap back on. A spare tube comes in the box.

### What is CPS mode for?

It offers three power curves, C1, C2 and C3, adjustable from 5 to 80W with a starting point of 10W. The manual gives the range and the starting value, but does not describe the profile of each curve.

## Aspire Zelos M80, a kit with two draws

The Aspire Zelos M80 keeps two of its three promises. With the 1.8 ohm BVC and a closed ring, it gives a tight draw, and with the 0.3 ohm Meshed and an open ring, restricted direct lung. The direct lung vaping claimed on the product page needs a different tank.

Choosing the **Aspire Zelos M80** therefore means choosing the tank and coil that go with it, before the wattage shown on the mod. Reading each kit by its draw is the approach we apply to every vaping device we look at on this site.

<em>Editorial content for adult readers only. Vaping products can contain nicotine, which is a highly addictive substance. Vaping products are not for sale to anyone under 18 in the UK. This article is not a buying recommendation.</em>
